What I really dread is getting the chest size wrong.that would be a pain to have to start over/resize.so I will probably go with a LD file/tester to get it dialed in before going HD, although I have seen some LD work that was modified and looks pretty close to HD with the end result. I have v3.0 printed out but not started - finishing up the cutting on my left boot currently (right one is glued up) - and will start on that next. When I did my v1.0 I inadvertently used the scaling number for an ODST helmet for the Mk VI and think that had a lot to do with the oversized result For v2.0 I went a little (heh.little) too conservative. Thanks for the link! I have read through a couple of the sizing tutorals and think I have a handle on it.
its a little hard to navigate but youll get the hang of it.
